Video: International PowerShell User Group Day with Ed Wilson, Don Jones & Jonathan Walz
On March 19th 2012 the first meeting of the International PowerShell User Group Day was broadcast live from Interface Technical Training. This special event was a chance for PowerShell user groups and special guests to gather as a community.
We broadcast the event live 3 times that day to hit the different time zones. I was fortunate enough to be the Emcee for the show as we spoke with some of the PowerShell community largest contributors. The speakers, Ed Wilson (The ScriptingGuy), PowerShell MVP Don Jones, and Jonathan Walz (PowerScripting Podcast) were on board for an amazing event.
If you watch the videos, keep an eye on the chat room where we also had Distinguished Engineer Jeffrey Snover stop by!
Part 1:
Part 2:
Part 3:
Knowledge is PowerShell,
Jason Helmick
Director of PowerShell Technologies
Interface Technical Training
A Simple Introduction to Cisco CML2
Mark Jacob, Cisco Instructor, presents an introduction to Cisco Modeling Labs 2.0 or CML2.0, an upgrade to Cisco’s VIRL Personal Edition. Mark demonstrates Terminal Emulator access to console, as well as console access from within the CML2.0 product. Hello, I’m Mark Jacob, a Cisco Instructor and Network Instructor at Interface Technical Training. I’ve been using … Continue reading A Simple Introduction to Cisco CML2
Configuring Windows Mobility Center and How to Turn it On and Off
Video transcription Steve Fullmer: In our Windows training courses, we often share information about the Windows 8.1 Mobility Center. Mobility Center was introduced for mobile and laptop devices in Windows 7. It’s present and somewhat enhanced in Windows 8. Since we don’t have mobile devices in our classrooms, I decided to take a little bit … Continue reading Configuring Windows Mobility Center and How to Turn it On and Off
OSPF Adjacency Troubleshooting Solution – Getting Close to the OSPF adj
In this video, Cisco CCNA & CCNP instructor Mark Jacob shows how to troubleshoot OSPF Adjacency issues by showing the distance between routers with the show ip ospf neighbor command.
Write a Comment
